beautypg.com

F.3.2 front panel menu operations, F.3.3 select: (main) menu – Comtech EF Data CDM-600/600L User Manual

Page 254

background image

CDM-600/600L Open Network Satellite Modem

Revision 3

Appendix F

MN/CDM600L.IOM

F–4

F.3.2

Front Panel Menu Operations

The ODU menu allows the user to access an FSK menu that permits the CDM-600L to interface
directly with an FSK-capable BUC. The interface is accomplished using a low-speed, half-duplex
FSK link on the Tx IF port, with a carrier frequency around 650 kHz.

Configuration menus for the LNB and BUC allow the user to set up the power supply, 10 MHz
reference and low/high current alarm thresholds for the BUC and LNB, and power-up carrier output
turn-on delay for the BUC. LO menus for the BUC and LNB allow the user to set up the up-convert
and down-convert parameters for the BUC and LNB so that the TX and RX frequencies are handled
as the satellite frequencies rather than the modem IF input/output frequencies.

F.3.3

SELECT: (Main) Menu

Select: CONFIGURATION TEST INFORMATION
MONITOR STORE/LOAD UTILITY ODU FAST

The following table identifies the menu branch, its content section in this appendix, and the
functional description of each branch that incorporates or is dedicated to ODU-specific operations:

Menu Branch*
(Appendix Sect.)

Description

ODU (F.3.4)

(Outdoor Unit) Permits the user to monitor and control a Comtech EF Data Block
Upconverter (BUC) or Low-noise Block Downcoverter (LNB), if connected.

Monitor (F.3.5)

Permits the user to monitor the current status of the ODU and view the log of stored
events for the ODU.

* To prioritize operational sequence, the ODU menu information featured here is presented out of
the selection order displayed on the Main menu.

Select ODU or, once configured for proper ODU operation, Monitor using the [

][] arrow

keys, then press [ENT].