Fast accessible options – Comtech EF Data CDM-600/600L User Manual
Page 42

CDM-600/600L Open Network Satellite Modem
Revision 3
Introduction
MN/CDM600L.IOM
1–14
See Appendix C. FAST ACTIVATION PROCEDURE for further information.
FAST Accessible Options
Hardware options for basic modems can be ordered and installed either at the factory or in the
field. The operator can select options that can be activated easily in the field, depending on the
current hardware configuration of the modem. A unique access code enables configuration of the
available hardware.
The base CDM-600/600L unit is equipped with Viterbi, Sequential and Reed-Solomon codecs. It
offers BPSK, QPSK, and OQPSK modulation types, and data rates up to 5.0 Mbps, with all
interface types. While it is limited to Closed Network operation, the base unit does include
EDMAC and AUPC.
The following table shows the available FAST and FAST-accessible hardware options:
Option
CDM-
600
CDM-
600L Description and Comments
Option
Installation
Method
Low Rate Variable
X X
Data rate 2.4 to 5.0 Mbps
BASE UNIT
Mid-Rate Variable
X X
Data rate 2.4 to 10.0 Mbps
FAST
Full Rate Variable
X X
Data rate 2.4 kbps to 20.0 Mbps
FAST
8-PSK
X X
Modulation Type
(includes 8-QAM if the TPC / LDPC Codec is installed)
FAST
16-QAM
X X
Modulation Type
FAST
High Rate IBS ESC
X X
20 bits per Frame
FAST
IBS
X X
Intelsat Business Services – IESS-309
FAST
IDR
X X
Intermediate Data Rate – IESS-308
FAST
D&I
X X
Drop and Insert (includes D&I++, S/W Ver 1.2.0 or higher)
FAST
Dual Audio mode
X X
2 x 32 kbps ADPCM Audio as primary data
FAST
Turbo Codec – Low Rate (1
st
Gen)
X X
5 Mbps TPC Codec
Hardware
Turbo Codec – High Rate (2
nd
Gen)
X X
20 Mbps TPC Codec
Hardware
TPC / LDPC Codec
X X
20 Mbps TPC/LDPC Codec
Hardware
LDPC (Mid-Rate)
X X
Data rate to 10 Mbps
FAST
LDPC (High-Rate)
X X
Data rate to 20 Mbps
FAST
High Stability Reference
X
Internal/External 10 MHz reference - 2 x 10
-8
Hardware
High Stability Reference*
X
Internal 10 MHz reference - 2 x 10
-8
Hardware
Low Stability Reference*
X
Internal 10 MHz reference – 1 x 10
-6
Hardware
75
Ω Rx Impedance*
X
75
Ω impedance with Type F female connector
Hardware
50
Ω Rx Impedance*
X
50
Ω impedance with Type N female connector
Hardware
BUC Power Supply
X
Internal 24V or 48V power supply for BUC
Hardware
*Factory installed only.
In order to operate in Turbo (TPC) Mode: To operate in the Low Rate range (up to 5 Mbps), the
modem requires any of the three Codec cards to be installed.
To operate in the Mid- or High-Rate ranges (up to 10 or 20 Mbps), the modem requires either the
High Rate TPC Codec or the TPC / LDPC Codec to be installed.
In order to operate in LDPC Mode: The unit will require the TPC/LDPC Codec to be installed. In
the base configuration this will provide LDPC up to 5 Mbps. In order to operate at higher data rates,