beautypg.com

Comtech EF Data CDM-600/600L User Manual

Page 211

background image

CDM-600/600L Open Network Satellite Modem

Revision 3

Appendix D

MN/CDM600L.IOM

D–19

Parameter

Type

Command

(Instruction

Code and

Qualifier)

Arguments for

Command or

Response to

Query

Description of Arguments

Response to

Command

Query

(Instruction

Code and

Qualifier)

Response to Query

Rx Spectrum
Invert

RSI=

1 byte, value of
0 or 1

Command or Query.
Rx Spectrum Invert, where:
0=Normal
1=Rx Spectrum Invert

Example: RSI=0 (selects Normal)

RSI=
RSI?
RSI*
RSI#

RSI? RSI=x

(see Description of
Arguments)

Rx Signal
Level

N/A 5

bytes

Query

Only.

Unit returns the value of the Rx signal level, in dBm, between –20 and
–60 dBm:

• If >-20dBm, returns RSL=GT-20 (GT means ‘greater than’)
• If in the range of –20 to –60dBm, returns RSL===-xx
• If <-60 dBm, returns RSL=LT-60 (LT means ‘less than’)

Example: RSL=== -45 (–45 dBm)

N/A RSL?

RSL=xxxxx
(see Description of
Arguments)

Rx Symbol
Rate

N/A 9

bytes,

numeric

Query only.
Returns the Rx symbol rate (shown on front panel), where in the form
ddddd.ddd

RSR?
RSR=

RSR? RSR=ddddd.ddd

(see Description of
Arguments)

Rx Demod
Acquisition
Sweep Width

RSW=

2 bytes

Command or Query.
Rx

± acquisition sweep range of demodulator, in kHz, ranging from

±1 to ±32 kHz.

Example: RSW=09 (selects

±9kHz)

RSW=
RSW?
RSW*
RSW#

RSW?

RSW=xx
(see Description of
Arguments)

Rx Ternary
Code

RTC=

1 byte, value of
0 thru 3

Command or Query.
(G.703 Parameter)
Rx Ternary Code, where:
0=AMI
1=B8ZS
2=B6ZS
3=HDB3

Example: RTC=1 (selects B8ZS)

RTC=
RTC?
RTC*
RTC#

RTC?

RTC=x
(see Description of
Arguments)

Receive
Terrestrial
Alarm Enable

RTE=

1 byte, value of
0 or 1

Command or Query.
(Insert mode parameter)
Receive Terrestrial Alarm Enable conditions, where:
0=Disables the alarm
1=Enables the alarm.

Example: RTE=0 (Alarm disabled).

RTE=
RTE?
RTE*
RTE#

RTE? RTE=x

(see Description of
Arguments)

Rx Audio
Volume
Control

RVL=

4 bytes

Command or Query.
(Audio/IDR Parameter)
Rx Audio Volume control, in the form aabb, where:
aa=Rx 1 volume control in dB, values defined below.
bb=Rx 2 volume control in dB, values defined below.
Valid values: -6, -4, -2, +0, +2, +4, +6, +8

Example: RVL= -2+4 (sets Rx 1 to –2 dB and Rx 2 to +4 dB)

RVL=
RVL?
RVL*
RVL#

RVL? RVL=aabb

(see Description of
Arguments)