beautypg.com

1 front panel led indicators – Comtech EF Data CDM-600/600L User Manual

Page 78

background image

CDM-600/600L Open Network Satellite Modem

Revision 3

Front Panel Operation

MN/CDM600L.IOM

5–2

5.1.1

Front Panel LED Indicators

IMPORTANT

In general, the Alarm relay state will reflect the state
of the Front Panel LEDs. For instance, if the Unit
Status LED is red, the Unit Alarm relay will be active,
etc. The one exception is the Transmit Traffic relay.
This will only be activated if a Transmit Traffic Fault
exists – it does not reflect the state of the TX carrier.

The function of the eight front panel LED indicators is as follows:

LED

CONDITION

DESCRIPTION

UNIT

STATUS

Green

No Unit Faults, or Traffic Faults

Orange

No Unit Faults, but a Traffic Fault exists

Red

A Unit Fault exists (Example: PSU fault)

TRANSMIT

TRAFFIC

Green

No Tx Traffic Faults

Flashing

CDM-600L ONLY:

On/Off once per second. The carrier-on delay is active.

Refer to ODU, BUC, Config menu for setting countdown seconds remaining.
It also is indicated via the Remote Command: TXO?; response: TXO=4,
which means, OFF due to BUC carrier-on-delay.

Off

A Tx Traffic fault exists OR the Tx Carrier is in OFF state

RECEIVE

TRAFFIC

Green

No Rx Traffic Faults (demod and Viterbi decoder are locked, everything is
OK)

Off

An Rx Traffic fault exists (the demod may still be OK)

ON LINE

Green

The Unit is On Line, and carrying traffic

Off

The Unit is Off Line (standby) – forced by externally connected 1:1 or 1:N
redundancy system

STORED

EVENT

Orange

There is a Stored Event in the log, which can be viewed from the front panel,
or retrieved via the remote control interface

Off

There are no Stored Events

REMOTE

Orange

The Unit is in Remote Mode – local monitoring is possible, but no local
control

Flashing

CDM-600 ONLY:

ODU control has been enabled, and there is a

communications fault, or there is an ODU status fault

Off

The Unit is in Local Mode – remote monitoring is possible, but no remote
control

EDMAC

MODE

Orange

Framing on, EDMAC on, and unit defined as Slave – local monitoring is
possible, but no local control

Off

Either no EDMAC, EDMAC Master, or Transparent mode is selected

TEST

MODE

Orange

A Test Mode is selected (Example: IF Loopback)

Off

There is no Test Mode currently selected