Comtech EF Data CDM-600/600L - Manual (Page 246)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix E MN/CDM600L.IOM
E–16
INFORMATION: LNA
INFO: LNA:OFF FAULT-LOGIC:SUMMARY
WINDOW:48%
Per the example shown, this read-only display provides the current state of the LNA functions:
the LNA operating status (ON or OFF), the Current Window, the Fault-Logic setting
(SUMMARY or NO-SUMM), Current-Window threshold setting.
E.3.3.2 (SELECT:) ODU (KST-2000A/B Transceiver)
ODU CONTROL=ENABLE (DISABLE/ENABLE)
SYSTEM TYPE=STANDALONE (STANDALONE,1:1)
Select the parameter to edit – ODU CONTROL or SYSTEM TYPE – using the [
←][→] arrow
keys, then use the [
↑][↓] arrow keys to modify that parameter setting. Press [ENT] when done.
Observe the following:
ODU CONTROL:
DISABLE, ENABLE
DISABLE turns OFF the FSK link to the ODU.
ENABLE turns ON the FSK link to the ODU. Once the FSK link to the ODU is
enabled, the CDM-600 senses the active ODU model and automatically
adjusts the front panel menu displays specific for that product (i.e., CSAT-5060
or KST-2000A/B).
SYSTEM TYPE:
(STANDALONE)
If the CDM-600 detects a KST-2000A/B ODU in use, this selection defaults to
STANDALONE: Note that 1:1 is disabled and non-selectable, and the user is
directed to the KST SELECT: menu depicted next.
ODU: STANDALONE
Æ KST SELECT
KST SELECT:
CONFIGURATION INFORMATION ALARMS
Select CONFIGURATION, INFORMATION, or ALARMS using the [
←][→] arrow keys,
then press [ENT].
E.3.3.2.1 KST SELECT: CONFIGURATION
KST CONFIG:
TX-PARAM RX-PARAM MISCELLANEOUS
Select TX-PARAM, RX-PARAM, or MISCELLANEOUS using the [
←][→] arrow keys, then
press [ENT].