Comtech EF Data CDM-600/600L - Manual (Page 232)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix E MN/CDM600L.IOM
E–2
E.2 ODU Operations via Serial Remote Control
For a complete overview of Serial Remote Control and the commands and queries associated with
remote ODU configuration, operation, and monitoring, refer to Appendix D. SERIAL
REMOTE CONTROL.
E.2.1 Remote Control Address Setup
The Outdoor Unit (ODU) connected to a CDM-600 Modem through FSK can be remotely
monitored and controlled by using ODU remote commands through Serial Remote or Telnet. The
address of the ODU is set up as follows:
• For local-end ODUs:
o Use Modem’s RC address + 1 for Standalone unit or Online unit in a 1:1 Redundancy
System.
o Use Modem’s RC address + 2 for Offline unit in a 1:1 Redundancy System.
• For distant-end ODUs in an EDMAC setup:
o Use EDMAC Slave Address (ESA) Range + 4 for Standalone unit or Online unit in a
1:1 Redundancy System.
o Use EDMAC Slave Address (ESA) Range + 5 for Offline unit in a 1:1 Redundancy
System.