beautypg.com

6 j12 ext ref (cdm-600l) / ext freq ref (cdm-600), 5 power / ground connections – Comtech EF Data CDM-600/600L User Manual

Page 71

background image

CDM-600/600L Open Network Satellite Modem

Revision 3

Rear Panel Connector Pinouts

MN/CDM600L.IOM

3–11

3.4.6 J12 Ext Ref (CDM-600L) / Ext Freq Ref (CDM-600)

CDM-600L: This 50

Ω BNC female connector provides an external reference input

for the Tx and Rx IF synthesizers, and for the internal transmit clock. The load
impedance is 60.4

Ω, so the VSWR is less than 1.25:1 at either 50Ω or 75Ω. Input

level is 0 dBm minimum to +20 dBm maximum at 1, 2, 5, 10, or 20 MHz. When

external reference is enabled, the internal 10 MHz reference oscillator is phase locked to the
external reference input by a 10Hz bandwidth PLL. If no activity is present at the external reference
input, the modem will revert to the internal 10 MHz reference.

CDM-600 (optional): This is optional SMA female connector is used to permit the
connection of a high-stability external reference signal.



Modem

Connector

Connector

Type

Description

Direction

CDM-600L

J12 Ext Ref

BNC

External Synthesizer Reference Input

In

CDM-600

J12 Ext Freq Ref

SMA

High-stability External Reference Input

In

3.5 Power / Ground Connections

3.5.1 Alternating Current (AC) Power Connector (Standard)

A standard Type ‘IEC’ detachable, non-locking, 3-prong power cord
supplies the Alternating Current (AC) power to the modem.

Note the following:

AC Power Specifications

Input Power

CDM-600L: 290W maximum, 55W typical without BUC power supply
CDM-600: 40W maximum, 30W typical

Input Voltage

100-240 VAC, +6%/-10% - autosensing
(total absolute max. range is 90-254 VAC)

Connector Type

IEC

Fuse Protection

CDM-600L: Line and neutral fusing
5.0A Slow-blow 20mm fuse CEFD P/N FS/5ASB-IEC
(115 and 230 VAC operation)
CDM-600: Line and neutral fusing
T1.25A Slow-blow 20mm fuse (115 VAC operation)
T0.75A Slow-blow 20mm fuse (230 VAC operation)

IMPORTANT

For continued operator safety, always replace the fuses with
the correct type and rating.