Warranty policy – Comtech EF Data CDM-600/600L User Manual
Page 25

CDM-600/600L Open Network Satellite Modem
Revision 3
Preface
MN/CDM600L.IOM
xix
EN 61000-4-9
Pulse Magnetic Field Immunity
EN 61000-4-11
Voltage Dips, Interruptions, and Variations Immunity
EN 61000-4-13
Immunity to Harmonics
IMPORTANT
To ensure that the Modem continues to comply with these standards,
observe the following instructions:
• Connections to the transmit and receive IF ports (Type ‘BNC’ female connectors for the
CDM-600, Type ‘N’ or ‘F’ female connectors for the CDM-600L) should be made using
a good quality coaxial cable; e.g., RG58/U (50
Ω) or RG59/U (75Ω).
• All 'D' type connectors attached to the rear panel must have back-shells that provide
continuous metallic shielding. Cable with a continuous outer shield (either foil or braid,
or both) must be used, and the shield must be bonded to the back-shell.
• The equipment must be operated with its cover on at all times. If it becomes necessary to
remove the cover, the user should ensure that the cover is correctly re-fitted before
normal operation commences.
Warranty Policy
Comtech EF Data products are warranted against defects in material and workmanship
for a specific period from the date of shipment, and this period varies by product. In
most cases, the warranty period is two years. During the warranty period, Comtech EF
Data will, at its option, repair or replace products that prove to be defective. Repairs are
warranted for the remainder of the original warranty or a 90 day extended warranty,
whichever is longer. Contact Comtech EF Data for the warranty period specific to the
product purchased.
For equipment under warranty, the owner is responsible for freight to Comtech EF Data
and all related customs, taxes, tariffs, insurance, etc. Comtech EF Data is responsible for
the freight charges only for return of the equipment from the factory to the owner.
Comtech EF Data will return the equipment by the same method (i.e., Air, Express,
Surface) as the equipment was sent to Comtech EF Data.
All equipment returned for warranty repair must have a valid RMA number issued prior
to return and be marked clearly on the return packaging. Comtech EF Data strongly
recommends all equipment be returned in its original packaging.
Comtech EF Data Corporation’s obligations under this warranty are limited to repair or
replacement of failed parts, and the return shipment to the buyer of the repaired or
replaced parts.