Comtech EF Data CDM-600/600L - Manual (Page 199)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix D MN/CDM600L.IOM
D–7
Section D.6 Notes:
1. The remote commands and queries are arranged as subsections of this chapter as follows:
• Sect. D.6.1 Transmit (Tx) Commands and Queries
• Sect. D.6.2 Receive (Rx) Commands and Queries
• Sect. D.6.3 Unit Commands and Queries
• Sect. D.6.4 Queries
• Sect. D.6.5 Bulk Commands and Queries
• Sect. D.6.6 BUC Commands and Queries (CDM-600L ONLY)
• Sect. D.6.7 LNB Commands and Queries (CDM-600L ONLY)
• Sect. D.6.8 High-Stability Reference Option Commands and Queries (CDM-600 ONLY)
2. A command/query that is unique to the CDM-600L is noted in the ‘Parameter Type’ column as (CDM-600L ONLY) .
Similarly, a command/query that is unique to the CDM-600 is noted in the ‘Parameter Type’ column as (CDM-600 ONLY) .
For commands and queries common to both the CDM-600/600L, any operational difference is noted accordingly in the ‘Description of
Arguments’ column.
3. Typical for all tablature, the following codes are used in the ‘Response to Command’ column:
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
~ Time out of an EDMAC pass-through message (added for CDM-600 in FW Ver 1.1.5)
+ Warning: Command accepted, but other parameters were changed in addition