Comtech EF Data CDM-600/600L - Manual (Page 215)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix D MN/CDM600L.IOM
D–23
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Outdoor Unit
Comms
enable ODU= 1 byte, value of
0 or 1 Command or Query.
Enables or disables communications, via the FSK link, with a
compatible Comtech EF Data outdoor unit (ODU), where:
0=Disabled
1=Enabled
Example: ODU=0 (Disabled)
ODU=
ODU?
ODU*
ODU# ODU? ODU=x
(see Description of
Arguments)
ReCenter
Buffer RCB= None Command only
Forces the software to recenter the Rx Plesiochronous/Doppler buffer.
Example: RCB=
Note: This command takes no arguments.
RCB=
RCB?
RCB*
RCB# N/A N/A
Retrieve next
5 unread
Stored Events N/A 80 bytes Query only.
Unit returns the oldest 5 Stored Events which have not yet been read
over the remote control, in the reply form [CR]Sub-body[CR]Sub-
body[CR]Sub-body[CR]Sub-body[CR]Sub-body;
Sub-body = ABCddmmyyhhmmss, where:
A being the fault/clear indicator.
F = Fault
C = Clear
I = Info
B being the fault type where:
1 = Unit
2 = Rx Traffic
3 = Tx Traffic
4 = Power on/off, or log cleared
5 = Open Network
C is Fault Code number (as in FLT?) or Info Code, which is:
0 = Power Off
1 = Power On
2 = Log Cleared
3 = Global Config Change
4 = Redundancy Config Change
If there are less than 5 events to be retrieved, the remaining positions are
padded with zeros. If there are no new events, the response is RNE*.
N/A RNE? RNE=[CR]ABCddmmyyh
hmmss[CR]ABCddmmyy
hhmmss[CR]ABCddmmy
yhhmmss[CR]ABCddmm
yyhhmmss[CR]ABCddm
myyhhmmss
(see Description of
Arguments)