Conventions and references, Metric conversion, Cautions and warnings – Comtech EF Data CDM-600/600L User Manual
Page 22: Recommended standard designations, Electrical safety, Conventions and references metric conversion

CDM-600/600L Open Network Satellite Modem
Revision 3
Preface
MN/CDM600L.IOM
xvi
Conventions and References
Metric Conversion
Metric conversion information is located on the inside back cover of this manual. This information
is provided to assist the operator in cross-referencing non-metric to metric conversions.
Cautions and Warnings
CAUTION
CAUTION indicates a hazardous situation that, if not avoided, may
result in minor or moderate injury. CAUTION may also be used to
indicate other unsafe practices or risks of property damage.
WARNING
WARNING indicates a potentially hazardous situation that, if not
avoided, could result in death or serious injury.
IMPORTANT
Indicates information critical for proper equipment function.
Recommended Standard Designations
Recommended Standard (RS) is equivalent to the new designation of the Electronic Industries
Association (EIA). While either designation is acceptable, Comtech EF Data has elected to
continue use of the old (RS) designation in its documentation.
Electrical Safety
IMPORTANT
The user should make special note of the following information and instructions:
The CDM-600/600L Satellite Modem has been shown to comply with the following safety standard:
• EN 60950: Safety of Information Technology Equipment, including Electrical Business
Machines.
The equipment is rated for operation over the range 100 - 240 VAC.
The CDM-600 has a maximum power consumption of 40 Watts and draws a maximum of 400mA.
The CDM-600L has a maximum power consumption of 290 Watts including maximum BUC
power supply load, and draws a maximum of 2.9 A. The CDM-600L DC-powered version is
rated for operation over the range of 38 to 60 VDC input.