Comtech EF Data CDM-600/600L - Manual (Page 240)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix E MN/CDM600L.IOM
E–10
E.3.3.1.3 COMMON ‘ODU SELECT’ SUBMENU
ODU
Æ Enable Æ SYSTEM TYPE=STANDALONE Æ
ODU
Æ Enable Æ SYSTEM TYPE=1:1 Æ ODU#1 Æ
ODU Æ Enable Æ SYSTEM TYPE=1:1 Æ ODU#2 Æ
SELECT: CONFIGURATION MONITOR ALARMS
INFORMATION
Select CONFIGURATION, MONITOR, ALARMS, or INFORMATION using the [
←][→]
arrow keys, then press [ENT].
E.3.3.1.3.1 ODU SELECT: CONFIGURATION
CONFIG: TX-PARAMETERS RX-PARAMETERS
LNA-PARAMETERS MISCELLANEOUS
Select TX-PARAMETERS (Transmitter configuration submenu), RX-PARAMETERS (Receiver
configuration submenu), LNA-PARAMETERS (Low-noise Amplifier configuration submenu), or
or MISCELLANEOUS (Miscellaneous configuration submenu) using the [
←][→] arrow keys, then
press [ENT].
CONFIGURATION
Æ TX-PARAMETERS
TX: FREQ=6427.0 MHz ATT=23.00 dB
AMP=OFF MUTE=UNMUTED SLOPE
Select the parameter to edit – FREQ, ATT, AMP, MUTE, or SLOPE – using the
[
←][→] arrow keys, then use the [↑][↓] arrow keys to modify that parameter setting.
Press [ENT] when done. Observe the following:
FREQ
(Frequency) Edit the Tx frequency by first selecting the digit to be edited using
the [
←][→] arrow keys, then changing the value of that digit using the [↑][↓]
arrow keys. Press [ENT] when done or [CLR] to cancel the edit and return to
the previous menu.
ATT
(Attenuation) Edit the Tx attentuation by first selecting the digit to be edited
using the [
←][→] arrow keys, then changing the value of that digit using the
[
↑][↓] arrow keys. Press [ENT] when done or [CLR] to cancel the edit and
return to the previous menu.
AMP (Tx Amplifier State) Select as ON or OFF.
MUTE (ODU Tx Mute State ) Select as MUTED or UNMUTED.
SLOPE Slope parameters are edited as per the information that follows.