Baby Lock Palette 10 (ECS10) Instruction Manual User Manual
Page 331

330
M
enus
/T
ools
a
nd Re
fe
re
nc
e
Sewing Attributes
■
If the entry/exit points of sewing have been changed
If the entry/exit points of line sewing with the motif stitch, stem stitch, candlewicking stitch or chain stitch have
been changed or optimized, select a setting for [Start/End Type] in the line sewing attributes.
cc
"Start/End Type" on page 326 and "Moving entry/exit points, the center point and stitch pattern
reference point" on page 50
If [Feed] was selected under [Start/End Type], jump stitches are entered at the beginning or end of pattern
stitching (with a motif stitch, stem stitch, candlewicking stitch or chain stitch). If [Run] was selected under
[Start/End Type], running stitches following the path are entered at the beginning of and between pattern
stitching.
a
• After changing the Start/End Type, check the stitching with the stitch simulator.
cc
"Checking the stitching with the Stitch Simulator" on page 80
• Embroidery patterns where the Start/End Type of line sewing with the motif stitch, have been changed or
optimized in an application earlier than version 8 are opened or imported with this stitching specified as
jump stitches.
Before the entry/exit points are changed
When the entry point is moved
Jump stitch
Running stitch
Path of actual stitching
Feed
Run
Entry point/Exit point
Entry point
Exit point
Exit point
Entry point