Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 173)

172
O
p
er
at
io
n
s f
o
r S
p
eci
fic Ap
p
lic
at
io
n
s
Tutorial 8-3: Creating a Cutwork Pattern Filled with Net Stitching
9
Specify the pattern spacing for the net fill stitch
in [Spacing].
 For this example, set it to [3.0 mm].
10
Specify the pattern direction of the net fill stitch
in [Direction].
 For this example, set it to [0°].
11
Specify satin stitching after cutting in
[Covering Satin Stitch].
Satin stitching is sewn along the edges of
inner cutouts.
The zigzag stitch or the stem stitch is used as
an underlay for the satin stitching.
 For this example, select [Yes].
Select the parameters according to the
procedure from step
12
to
13
, when
[Covering Satin Stitch] is set to [Yes].
12
Specify the width of the satin stitching in
[Width].
 For this example, set it to [4.0 mm].
13
Specify the density of the satin stitching in
[Density].
 For this example, set it to [6.5 line/mm].
14
Click [OK] to exit the [Cutwork Wizard].
2.0 mm 10.0 mm
0° 90°
3.0 mm 6.0 mm
5.0 line/mm 7.0 line/mm