Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 284)

283
Font Creator Window
The standard guidelines for creating fonts are
shown in the Design Pages. The contents of each of
the guidelines are as shown below.
1 Triangle icon
a
Base Line
b
Capital Line
The font's standard height will be from the
Base Line to the Capital Line line. These
line cannot be moved.
c
Mean Line
When in lower case, the standard height
of the font will be from the Base Line to
this line. It can be moved by dragging the
triangle icon on the right edge.
d
Descender Line
This line is the standard for characters
with parts that hang down (descenders)
such as "g" and "y". It can be moved by
dragging the triangle icon on the right
edge.
e
Ascender Line
This line is the standard for characters
with parts that extended above
(ascenders) such as the accent mark. It
can be moved by dragging the triangle
icon on the right edge.
f
Set Line (Left)
g
Set Line (Right)
This line will be the font width. The font
width can be adjusted by dragging the
triangle icon on the bottom edge.
About the Design Page
guidelines
e
b
c
a
d
f g
1
b
• The heights and widths specified for the [Base
Line], [Capital Line] and [Set Lines] are the
reference mask for creating the font character.
• When characters created with Font Creator are
imported into Layout & Editing, the width and
height of the characters will be in the following
area.
 Character height: from Base Line
a
to
Capital Line
b
 Character width: from Set Line (Left)
f
to Set
Line (Right)
g
• In order to align the height of the characters, the
[Ascender Line], [Mean Line] and [Descender
Line] appear the same with all characters.
Therefore, if the height of any of these lines is
changed, the setting is maintained, even when a
different character is selected to be edited.
• The widths of the [Set Lines] can be set
separately for each character.