Baby Lock Palette 10 (ECS10) Instruction Manual User Manual
Page 209

208
T
ran
sf
er
rin
g
Da
ta
Using the Link Function to Embroider From the Computer
■
Changing the embroidery
machine name appearing with the
Link function
1
Click [Machine Name] in the [Option] menu
of the queue whose name is to be changed.
2
Type the name in the [Machine Name] box,
and then click [OK].
b
• The embroidering order of designs in the queue
can be changed.
cc
For details, refer to "If multiple designs were
sent to a single machine" on page 206.
• If additional machines are connected while the
[Link] dialog box is displayed, corresponding
queues will appear. If a machine is
disconnected, the corresponding queue will
disappear.
• To display the [Property] dialog box for a file,
double-click the file's icon, or click a file to select
it, right-click it, and then click [Property] from
the menu that appears.
• To reduce this dialog box to a button on the
taskbar, click the [Minimize] button.
To disconnect the USB cable, or shut down the
computer
• After data transferring to embroidery machine
and the transferring message on the screen of
the machine is closed, you can disconnect the
USB cable, or shut down the computer.
When connected to the embroidery machine
again, you can continue the Link operation.
• The embroidery machine can finish sewing the
design currently being embroidered even if the
computer is turned off.
• If the embroidery machine is turned off while it is
embroidering, the resume operation can be
used the next time it is turned on. At that time,
transmission can be resumed using the Link
function by clicking [Link] in [Design Database]
or in the [Option] menu of [Layout & Editing]
to display the [Link] dialog box.
• If the embroidery machine connection cannot be
detected, the [Link] dialog box will close
automatically.
• To display the [Link] dialog box again after the
computer has been restarted, click [Link] in
[Design Database] or in the [Option] menu (in
the upper-right corner) of [Layout & Editing].
• To display the [Distributor] dialog box, click
[Distributor] in the [Option] menu of the [Link]
dialog box.
b
A name (up to 10 alphanumeric characters/
symbols) can be specified for the embroidery
machine.
a
• When an embroidery machine is connected to
the computer, the embroidery machine is
recognized by the computer as a removable disk
and is assigned a drive letter. If this drive letter
is the same as one that has already been
assigned by the computer, designs cannot be
sent from the computer to that embroidery
machine. This problem occurs, for example, if a
network drive has been assigned a computer
drive letter. If this occurs, cancel the assignment
for the drive with the conflicting drive letter.
• When the number of embroidery machines
connected to the computer via USB is
increased, the operating system may require
that the computer be restarted. At that time,
restart the computer.