215 basic design center operations 3, Adding lines to the figure handle image 1, Reshaping outlines 1 – Baby Lock Palette 10 (ECS10) Instruction Manual User Manual
Page 216

215
Basic Design Center Operations
3
Move the pointer over the outline so that the
shape of the pointer changes to
, and then
drag the outline.
■
Adding lines to the figure handle
image
1
Click [Input Line] in the [Tools] group.
2
Click the start point (1), and then click the next
point (2).
A line is drawn connecting the two points.
Continue clicking to draw additional lines.
3
Double-click the end point.
■
Reshaping outlines
1
Click [Select Point] in the [Tools] group.
2
Click an outline.
1
Point
2
Pink Line
3
To add a point, click the outline (1).
To create a corner, drag the point (2).
b
Drag a handle to change the size or angle. To
delete the outline, press the
b
• To remove the last point that was entered, right-
click.
• To draw vertical or horizontal lines, hold down
the
2
1
1
2
1
2