Baby Lock Palette 10 (ECS10) Instruction Manual User Manual
Page 205
204
T
ran
sf
er
rin
g
Da
ta
Using the Link Function to Embroider From the Computer
Using the Link Function to Embroider
From the Computer
Embroidery designs can be embroidered by transferring the embroidery data from the
computer to one or more embroidery machines compatible with the Link function. These
embroidery designs are embroidered after the data is sent from the computer to the
embroidery machine in the same way that a document is printed after the data is sent from
a computer to a printer.
1
Create an embroidery design in [Layout &
Editing].
2
Set the embroidery machine in Link mode.
• Turn on the Link function of the embroidery
machine, and then turn off the machine.
3
Use the USB cable included with the
embroidery machine to connect the machine
to the computer.
• Turn on the embroidery machine.
4
Click the [Home] tab.
a
• The Link function can be used only with
embroidery machines compatible with the
function; it cannot be used with other machines.
For details, refer to the Operation Manual
provided with your embroidery machine.
• The Link function cannot be used with the
following embroidery designs.
Size exceeds the area that can be
embroidered with the machine
Embroidery designs in a Design Page of a
custom size or for the jumbo frame
Patterns for the 240 × 360 mm hoop
• Up to four embroidery machines can be
connected using the Link function.
a
For details on setting the machine in Link mode,
refer to the Operation Manual provided with your
embroidery machine.
a
• For details on connecting the machines to the
computer, refer to the Operation Manual
provided with your embroidery machine.
• If the machine is positioned far from the
computer, we recommend you to use a self-
powered USB hub. Do not use USB extension
cables or repeater cables.
• Do not connect or disconnect the USB cable
while the machine is turned on.
• Select [Power Options] in [Control Panel], and
then set both [System standby] and [System
hibernates] to [Never].
b
One or more embroidery machines can be
connected to PC by using the Link function.