Juniper Systems Allegro CX Manual - Manual (Page 52)

52 Allegro CX Owner’s Manual
Insert the card socket-fi rst with the front of the card facing the
door. Gently push it in until it stops.
Note: Be careful when inserting and removing cards. Excess force could
damage the card and the card drive. If the system tray indicator for the PC
card activity is on, the computer is writing to the card. Do not turn off the
Allegro and remove the card until the indicator stops blinking. Incomplete
fi les can corrupt the data already stored on the card.
Close the door to the PC card slot.
Turn each screw clockwise ¼ turn to seal the compartment.
Changing Cards
Because of the versatility of the Allegro, you can save your data to
one PC card and remove it to take to the offi ce while replacing the
card with a new one to continue collecting data. To remove a card
from the card slot in your Allegro, complete the following steps:
Open the card door as previously outlined.
Push the eject button.
Grasp the card fi rmly and pull it out.
To install a new card after removing one, follow steps 3 – 5 in the
Inserting Cards section.
Displaying Information about the PC Card
To display information about the installed PC card such as the card
type and the name of the manufacturer, complete the following
steps:
Tap on Start | Settings | Control Panel | System.
Tap on the General tab to view this information.
3)
‡
4)
5)
▲
1)
2)
3)
▲
1)
2)