Juniper Systems Allegro CX Manual - Manual (Page 30)

30 Allegro CX Owner’s Manual
Installing the NiMH Battery Pack
When you receive the Allegro, you must install and then charge the
NiMH battery pack. To do this, complete the following steps:
Push up on the sliding latches on the sides of the Allegro to open
the battery compartment door.
Place the NiMH battery pack in the left side of the battery
compartment, push down, and slide it all the way to the right.
There is a small arrow on the bottom right corner of the battery
pack, make sure the arrow is pointing to the right when it is
placed in the Allegro.
Push the battery door closed until each slide latch clicks into
place.
Slide the latches downward until they cannot slide any further to
securely close the battery door.
Do not turn on the Allegro yet.
Plug the AC wall charger that came with the Allegro into the wall
socket. A small green light on the wall charger turns on when it is
plugged in and receiving power.
Remove the rubber protector from the Allegro’s external power
input jack.
Plug the power connector end of the wall charger into the Allegro
power jack, which turns on the Allegro. The New Battery Detected
screen pops up requesting you to set the charge percentage. Set
the battery charge to 10%. (See the New Battery Detected Screen
section of this chapter for details.)
▲
1)
2)
3)
4)
5)
6)
7)