Juniper Systems Allegro CX Manual - Manual (Page 260)

260 Allegro CX Owner’s Manual
For More Information
Your GPS is now confi gured correctly to use the GPS pod. If you
have any questions or still cannot connect, please contact your
reseller or our customer service department at (435) 753-1881, or by
email at [email protected].
GPS Antenna Removal
The GPS antenna can be removed and reattached depending on your
needs. To remove the GPS antenna from your Allegro, complete the
following steps:
Unscrew the antenna cable from the Allegro expansion pod.
Loosen the thumbscrews on the antenna so that the antenna and
the two knobs at the end of the antenna clamp are no longer
securely fastened.
Pull the antenna off of the Allegro.
The antenna can be reattached to the Allegro by following the
instructions in the Attaching the Antenna section found previously
in this chapter.
GPS Installation Program
The GPS Set Up program is installed on your Allegro before it is
shipped. In the event that the GPS program gets removed from your
Allegro and needs to be reinstalled, complete the following steps:
Insert the Allegro CX Distribution CD shipped with your Allegro
into your PC’s CD-ROM drive and wait for the installation screen
to load.
Click on the Browse CD button on the installation screen.
Double-click on the Utilities Applications folder.
Double-click on the GPS Pod Setup Install folder.
Connect the Allegro to your PC through ActiveSync.
Double-click on the setup icon.
Follow the instructions given throughout the installation
program.
▲
▲
1)
2)
3)
▲
1)
2)
3)
4)
5)
6)
7)