Juniper Systems Allegro CX Manual - Manual (Page 110)

110 Allegro CX Owner’s Manual
Place the Allegro into the USB/Power Dock. The Allegro
automatically turns on and the Getting Connected screen
disappears.
The USB is the default port and should already be selected. To
double check the setting, complete the following steps:
Turn on the Allegro.
Tap the Start | Settings | Control Panel | PC Connection.
At the bottom of the dialog box under Connect to desktop using:
you see the COM port the Allegro is set on for the connection
process.
Tap the Change button to access the Change Connection screen
if you are using a different communication port than the listed
Connect using: port.
Select the USB port from the drop-down list.
Tap the OK button.
If the communication port you are using is not listed in the bottom
dialog box under Connect using, tap the Change button.
If the USB default is not selected, select the USB port from the drop-
down list. Tap the OK button.
To connect, remove the Allegro from the USB/Power Dock then
place it back into the USB/Power Dock. This automatically starts the
connection process.
A screen on the desktop PC that says Connecting is shown. The New
Partnership: Set Up a New Partnership appears. Proceed to the Setting
Up a Partnership section of this chapter.
Note: If you are having problems with the Allegro connecting to the
desktop PC while using the USB connection, perform a reset on the Allegro
and repeat the USB connection process.
3)
1)
2)
3)
4)
5)
‡