Juniper Systems Allegro CX Manual - Manual (Page 104)

104 Allegro CX Owner’s Manual
Click on the Next button and follow the instructions given to you
by the ActiveSync Setup program. When ActiveSync is installed
the following screen appears:
Click on the Cancel button on the Get Connected screen so you can
continue to set up the communication settings. The following
screen appears:
Click on the OK button.
Note: Depending on the operating system you are using on your
desktop PC, you may be instructed to restart your desktop PC before
completing the connection process.
Establishing a First Time ActiveSync Connection
There are two procedures for establishing a connection between
the Allegro and your PC. The fi rst is the fi rst-time ActiveSync
connection, and the second is for all connections after the fi rst one.
If you already have ActiveSync installed on your desktop PC,
proceed to the Establishing Additional ActiveSync Connections section
of this chapter. If you have just downloaded and installed ActiveSync
for the fi rst time, complete the steps outlined in this section.
2)
3)
4)
‡
▲