Juniper Systems Allegro CX Manual - Manual (Page 255)

Allegro CX Owner’s Manual 255
Insert the stylus that is attached to the antenna mount in place of
the stylus you removed. As you place the stylus in its slot on the
Allegro, slide the metal cover up into the stylus slot so that the
stylus fi ts into place.
Use two fi ngers, one on each prong of the stylus, and press it
securely into place.
Make sure the rubber stylus holders are not pressed inward or
they may pop the antenna out of the stylus holder. Removing the
rubber covers to the COM ports can help make this step easier.
Place the two knobs on the end of the antenna clamp into the
screw holes located above the COM ports of the Allegro.
Tighten the thumbscrews on the antenna so that the antenna is
securely fastened into place. You want the thumbscrews to be
snug, but do not over tighten them.
Remove the protective cap from the connector labeled GPS ANT
(save the cap for future use). Screw the antenna cable into the
connector.
You have completed the steps to attach the antenna to the Allegro
GPS Expansion pod.
GPS Pod Setup Program
The GPS Pod Setup program is factory installed on your Allegro. The
program allows you to confi gure the parameters of the internal GPS
receiver to accommodate the various GIS/GPS programs that run on
the Allegro.
The Allegro communicates with the internal GPS receiver via COM
3. The GPS Pod Setup program allows you to change the serial port
settings being used (i.e. baud rate, parity, stop bits), and to select
between TSIP and NMEA data output formats.
3)
4)
5)
6)
7)
8)
▲