Juniper Systems Allegro CX Manual - Manual (Page 127)

Allegro CX Owner’s Manual 127
When Save System utility is selected, the following message is shown:
Reset System
Reset System causes all running applications to close when selected.
If programs are not close and fi les are not saved, data may be lost.
After Reset System is selected, the system reloads data drivers and
programs that run at start-up time. A reset leaves all stored in RAM
intact.
Installation programs often request a reset so that the changes the
program made to the registry can be honored by system components
as they reload. A reset is also useful when applications misbehave
and render the system unusable.
You can execute a reset by selecting Start | Programs | Utilities |
Reset System, or by holding down the On/Off key for more than eight
seconds.
Restore System
Restore System erases RAM, including all running programs and
settings, and reloads the operating system. When the operating
system reloads, it automatically restores the Saved System Backup
from the C_Drive.
▲
▲