Juniper Systems Allegro CX Manual - Manual (Page 41)

Allegro CX Owner’s Manual 41
For more information about the Save System utility go to the System
Save/Restore Utilities section of Chapter 5.
Power Management Feature
To conserve power, the Allegro uses an Auto Suspend feature.
When the Allegro is on, it turns itself off if there is no activity after
a specifi ed period of time. This feature is on by default and is set
at eight minutes when the Allegro is using battery power. When
connected to an external power supply the Allegro is defaulted to
stay on until it is manually turned off by pushing the On/Off button.
To access the Auto Suspend settings, complete the following steps:
Tap on Start | Settings | Control Panel, double-tap on the Power
icon.
Tap on the Schemes tab.
Changing NiMH Battery Pack Changing NiMH Battery Pack
The battery compartment is accessed through a door in the back
of the Allegro case. Before you remove the battery pack from the
Allegro, complete the following steps:
Exit from all open programs.
Turn the Allegro off.
Push up on the sliding latches on the sides of the Allegro to open
the battery compartment door.
Slide the battery pack towards the left side of the battery
compartment and pull it out.
Place the new battery pack in the left side of the battery
compartment, with the small arrow on the battery pack in the
bottom right corner.
Push the battery pack down, and slide it all the way to the right.
Push the battery door closed until each side latch clicks into
place.
Slide the latches downward until they cannot slide any further to
securely latch the battery door closed.
▲
1)
2)
1)
2)
3)
4)
5)
6)
7)
8)