Juniper Systems Allegro CX Manual - Manual (Page 256)

256 Allegro CX Owner’s Manual
Specifying GPS Receiver Port Settings
To set up the parameters on the GPS Receiver Port Settings, complete
the following steps:
Go to Start | Programs | Utilities | GPS Pod Setup, and the GPS
Receiver Port Settings screen pops up.
At the bottom of the screen, there are three function buttons:
Get Settings
Apply Settings
Reset Receiver
Get Settings
The Get Settings button is used to see the receiver’s current settings
without changing the settings. Pressing Get Settings does a search
for the GPS receiver, which can take up to one minute to fi nd the
settings. Once the search is complete, the current settings for the GPS
receiver are shown.
Apply Setting
Tap on the Apply Settings button to save and apply new settings. To
make sure that your settings are applied correctly, press Get Settings
to check the parameters.
Reset Receiver
The Reset Receiver button returns the settings to their default setting.
This function enables you to start over in the event that an error was
made.
Tap on the Get Settings button and wait approximately one
minute for the settings to appear.
1)
‰
‰
‰
2)