Juniper Systems Allegro CX Manual - Manual (Page 44)

44 Allegro CX Owner’s Manual
Note: After plugging your Allegro into the wall adapter, check the
system tray icons and make sure the charge icon appears as a small
lightning bolt next to it or a plug icon appears if the battery is already fully
charged, verifying that the Allegro is charging.
Charging the Allegro when it is not in use helps the Allegro to avoid
inaccurate battery monitoring and having the battery discharge to
low levels.
Storing the Allegro CX for More Than Two Months
To protect the fi les on your Allegro and the unit itself during storage
periods of two months or more, complete the following steps:
Charge the battery to full capacity (100%).
Turn on your Allegro.
Tap on Start | Programs | Utilities | Save System to save all your
settings and data to your internal storage drive.
Turn off your Allegro.
Open the battery door on the back of the Allegro.
Remove the battery pack and close the battery door on the
Allegro.
Place the battery back in dry location with the open metal
conductors facing up.
Taking your Allegro out of Extended Storage
While storing the battery pack, it naturally discharges slightly while
being inactive. When you are ready to use your Allegro after storing
it for an extended period of time, complete the following steps:
Open the battery door on your Allegro and insert the battery
pack.
Close the battery door.
Turn on your Allegro.
Enter a 10 for the Specify Charge (%) option on the New Battery
Detected pop up screen.
Tap on the Accept button to save the new setting.
Plug your Allegro into the external AC wall charger and begin
charging the battery pack in your Allegro. Charge until the
lightning bolt indicator turns off and the battery status reads
100% charged.
‡
1)
2)
3)
4)
5)
6)
7)
1)
2)
3)
4)
5)
6)