Juniper Systems Archer 2 Quick Start - Manual

1 Loosen the 4 captive screws on the battery door with a #1 Phillips screwdriver. Remove the door.
CAUTION: The handheld is not sealed when the door is removed.
2 Place the battery pack into the compartment. Be sure to line up the and .
3 Replace the battery door and tighten the screws.
4 Plug the AC power charger into a wall socket and the DC jack on the handheld.
5 The handheld powers on and several screens appear. When the Time screen is shown make adjustments if
needed and select OK.
6 Charge the battery pack at room temperature for 5 hours.
The operating system, manual and quick start guide is available in English, Spanish, French, German,
and Brazilian Portuguese. Go to our website at www.junipersys.com/Archer-2/support.
© 2014 Juniper Systems, Inc. All rights reserved. Archer 2 is a trademark of Juniper Systems, Inc. Part Number: 23412-01
Power Button &
LED Indicators
Battery Door
Screws
12-24VDC Jack USB Client
Connector Module 9-pin Serial Port
Handstrap Tether
Microphone/Speaker Jack USB Host
Battery Pack SIM & SD Card Slots
Touchscreen Camera Lens (opt)
Bumper Barcode Window (opt)
Speaker
Perform Initial Tasks
Microphone Camera Flash/Flashlight (opt)
Stylus
Handstrap