Juniper Systems Allegro CX Manual - Manual (Page 49)

Allegro CX Owner’s Manual 49
USB/Power Dock (Optional Hardware)
Using the USB/Power Dock, you can quickly transfer and
synchronize fi les between the Allegro CX and a PC. The Allegro is
charged while it is docked, preparing it for tomorrow’s work day.
The USB/Power Dock is an optional two function component
designed for the Allegro CX. It is a charging base and a
communication base. The Power Dock is ordered separately for the
Allegro CX. The Power Dock has three LED (light) indicators on it,
with the function of each LED represented below:
Function LED Color
Power Supply Green
USB Communication Red
Charging Amber
Power Supply
The USB/Power Dock uses the AC wall adapter that comes with
the Allegro CX. Looking at the back of the USB/Power Dock is a 12
VDC adapter connector on the right. Plug the Allegro power adapter
into the Power Dock and then into the wall. When the green LED
indicator turns on, the Power Dock has power.
Charging
The USB/Power Dock is a charging device for the Allegro.
By placing the Allegro into the USB/Power Dock, the Allegro
automatically turns on and begins charging. When the amber LED
indicator turns off, the Allegro is fi nished charging. The amber LED
indicator turns on indicating the Allegro is properly seated in the
USB/Power Dock and that the unit is charging. The charging time is
the same whether the Allegro is turned on or off.
Note: Never operate the Allegro in the USB/Power Dock without a
battery installed. The Power Dock does not supply adequate power to the
Allegro for normal operation.
USB Communication
The USB/Power Dock also serves as a USB connection from the
Allegro to the desktop PC. The red LED indicator turns on when the
USB connection between the Allegro and desktop PC is active. The
connection and communication between the desktop PC and the
Allegro is achieved through ActiveSync. The USB port is used for
connecting single units.
▲
▲
‡
▲