Juniper Systems Allegro CX Manual - Manual (Page 42)

42 Allegro CX Owner’s Manual
Alkaline Battery Holder
The alkaline battery holder enables you to power the Allegro with
alkaline batteries. To properly use the alkaline battery holder,
complete the following steps:
Turn the Allegro off before changing the batteries.
The Allegro battery compartment is accessed through a door in
the back of the case. To open the compartment door, push up on
the release latches on the sides of the case. The door pops open.
Remove the alkaline holder or NiMH pack by sliding it to the left
and pulling it out.
Open the door to the alkaline battery holder by pressing in on
both tabs with your index fi nger and thumb (shown below).
Insert three fresh AA alkaline batteries, while taking care to
orient them correctly (only use alkaline batteries). Always replace
all three batteries at once (one weak battery greatly affects
performance).
Note: For best results, we recommend that you use Duracell Ultra or
Energizer Titanium alkaline batteries.
Slide the door to the alkaline holder back into place, while
making sure it snaps securely shut.
Place the alkaline battery holder in the left side of the Allegro
battery compartment. Put gentle pressure on the holder while
sliding it all the way to the right.
Push the battery door closed until each side latch clicks into
place.
Slide the latches downward until they cannot slide any further to
securely latch the battery door closed.
Occasionally check the battery task tray indicators on the Allegro
display while you are using the Allegro. When the battery power
gets low, replace the alkaline batteries or insert a NiMH pack.
▲
1)
2)
3)
4)
‡
5)
6)
7)
8)
9)