Juniper Systems Allegro CX Manual - Manual (Page 257)

Allegro CX Owner’s Manual 257
Record the settings for the following:
COM Port: COM3 – not changeable
Protocol:
Baud:
Parity:
Data Bit: (Note: Data Bit is always set at 8 and is not shown
in the set up)
Stop Bit:
The following are the default GPS pod settings:
COM Port: COM3 – not changeable
Protocol: TSIP
Baud: 9600
Data Bit: 8 – not changeable
Parity: None
Stop Bit: 1
Access the setup or confi guration menu in the GPS program.
Change the parameters on the GIS/GPS program’s confi guration
menu to match the default GPS pod settings or change the
parameters on your Allegro to match your program. If you
change the settings on your Allegro, tap on Apply Settings.
The COM Port and Data Bit are set and not changeable on the
Allegro. All GPS programs that offer these settings to be changed
must be set to the following Allegro settings:
COM Port: 3
Data Bits: 8
Connect the GPS. The Allegro must be outside in clear sky
conditions (this means free from tree foliage, buildings, power
lines, etc.) to receive a new GPS almanac. The receiver can take
up to 20 minutes to establish and receive the almanac.
Note: If your parameters do not match, some GPS programs (i.e.
ArcPad, TerraSync) produce an error message when attempting to activate
the GPS pod. This error means the communication parameters in the GPS
program do not match the GPS pod. Go back to the GPS programs set up
page and check to make sure those settings are the same settings as the
settings on your Allegro’s GPS Receiver Port Settings screen.
3)
4)
5)
6)
‡