Juniper Systems USB/Power Dock Pogo Pin - Manual

Allegro CE USB/Power Dock
Pogo Pin Replacment
These instructions show you how to replace the
connector pins in the USB/Power Dock. There are six
pins in each Power Dock that are the conductors for
connecting the Allegro CE to the Power Dock. These
pins need to be replaced if bent,
broken, or otherwise damaged.
Items Needed:
- Needle nose pliers
- Six gold plated popo pins
(in bag)
To replace the pogo pins
complete the following steps:
1. Unplug the power cable and
the USB cable from the Power
Dock.
Part # 13055-00
2. Using the needle nose pliers, grasp a pogo pin and
pull it straight out. Do Not grasp the protruding
portion of the pogp pin socket when you pull the
pin out.
3. Using your fingers, place the new pogo pin into the
empty pin slot.
4. Using your fingernail, push on the edge of the pogo
pin to slide it all of the way into the pin holder.
5. Now repeat the pr evious steps until all the new
pogo pins are installed.
6. Reconnect the power and USB cables to the Power
Dock. Y our Power Dock is now ready for use again.
Repairing the USB Power Dock
Occasionally the USB/Power Dock may need to be
returned for repair because of problems that cannot be
corrected by you. The following are situations where
you will need to return the USB/Power Dock:
1. A pogo pin socket is bent or loose.
2. A pogo pin has broken off in the socket and cannot
be pulled out.
Contact the company you purchased the USB/Power
Dock from or Juniper Systems, Inc. directly for
instructions on how to return the unit.
Release Date: November 2002
1740 North Research Park Way Phone: 435-753-1881
Logan, UT 84341-1977 USA E-mail: [email protected]
a Campbell Scientific Company
cut here
cut here
Document Number: 13196-00