Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 94)

-94-
4.2.62 gvrp time
Command:
gvrp time join-time leave-all-time
leave-time
join-time Set GARP protocol parameter JoinTime. See IEEE 802.1D-2004, clause 12.11
join-time in units of centi seconds. Range is 1-20. Default is 20.
leave-all-time Set GARP protocol parameter LeaveAllTime. See IEEE 802.1D-2004, clause 12.11
leave-all-time in units of centi seconds Range is 1000-5000. Default is 1000.
leave-time Set GARP protocol parameter LeaveTime. See IEEE 802.1D-2004, clause 12.11
leave-time in units of centi seconds. Range is 60-300. Default is 60.
Default:
Usage Guide:
To configure Join-time, Leave-time, Leave all-time for GVRP.
Example:
To configure Join-time, Leave-time, Leave all-time for GVRP as tabled below.
Switch# configure terminal
Switch (config)# gvrp time join-time 5 leave-all-time 1200 leave-time 150
4.2.63 help
Command:
help
Default:
N/A