74 poe pdcheck ip, 75 poe pdcheck action – Interlogix NS4702-24P-4S-4X Command Line Guide User Manual
Page 134

-134-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe mode plus
4.2.65.74 poe pdcheck IP
Command:
poe pdcheck IP
poe
Power Over Ethernet.
pdcheck
Allows user to enable or disable per port PD Alive Check function.
IP
To set PoE device IP address here for system making ping to the PoE device.
Default:
N/A
Usage Guide:
To configure Ping PD IP Address of PoE for specific interface
Example:
To configure Ping PD IP Address (10.101.10.10) of PoE for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck IP 10.101.10.10
4.2.65.75 poe pdcheck action
Command:
poe pdcheck action { reboot | alarm | reboot-alarm }
poe
Power Over Ethernet.
pdcheck
Allows user to enable or disable per port PD Alive Check function.
action
Allows user to set which action will be applied if the
PD
is without any response
alarm It
means system will issue an alarm message via Syslog, SMTP.
reboot It
means system will reset the PoE port that is connected to the PD.
reboot-alarm
It means system will reset the PoE port and issue an alarm message via Syslog, SMTP.