Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 271)

-271-
4.2.171 poe sequential interval
Command:
poe sequential interval <1-30>
poe
Power Over Ethernet
sequential
PoE sequential is to delay power feeding when the switch is completely booted.
interval
Set how long system should feeding power to next PoE interface <1-30>
<1-30>
poe sequential enable
Default:
5
Usage Guide:
To configure Sequential Power up Interval.
Example:
To configure Sequential Power up Interval (30 seconds per port).
Switch# configure terminal
Switch (config)# poe sequential interval 30
4.2.172 poe sequential rule
Command:
poe sequential rule { port | priority }
poe
Power Over Ethernet
sequential rule
PoE sequential is to delay power feeding when the switch is completely booted.
port
System sequential feeding power the PoE interfaces based port number.
priority
Use priority command to configure sequential feeding power to PoE interfaces based on port PoE priority.
Default:
Port
Usage Guide:
To configure Sequential Power up Port Option.
Example:
To configure Sequential Power up Port Option (Priority).
Switch# configure terminal
Switch (config)# poe sequential rule priority