Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 82)

-82-
Default:
V2
Usage Guide:
To configure ERPS VLANs for the specific profile.
Example:
To configure ERPS VLANs(VLAN5 - VLAN8) for the specific profile 1.
Switch# configure terminal
Switch (config)# erps 1 vlan add 5-8
4.2.51 evc
Command:
evc vid ivid interface ( * | 10GigabitEthernet |
GigabitEthernet [ ] ) learning [ disable ] policer { |
none | discard }
EVC identifier
vid
Setup EVC VLAN ID
EVC VLAN ID
ivid
Setup internal EVC VLAN ID
Internal VLAN ID
interface
Setup NNI
learning
Setup learning
policer
Policer (ingress bandwidth profile)
Policer ID
List of VLANs
discard
Map to policer discarding all frames
none
Map to policer allowing all frames
Default:
0
Usage Guide:
To configure Ethernet Virtual Circuits (EVC).
Example:
To configure Ethernet Virtual Circuits (EVC identifier: 1, EVC VLAN ID: 2, GigabitEthernet Port: 1/1, 1/2, Internal
VLAN ID: 3, Disable learning, Policer ID: 4)
.
Switch# configure terminal