Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 273)

-273-
4.2.175 poe temperature-threshold
Command:
poe temperature-threshold <0-100>
poe
Power Over Ethernet
temperature-threshold
Set a lower high temperature threshold for the secondary temperature alarm in degrees C.
<0-100>
Specifies the new threshold temperature.
Default:
80
Usage Guide:
To enable PoE Temperature Protection.
Example:
To enable PoE Temperature Protection (70 degrees C).
Switch# configure terminal
Switch (config)# poe temperature-threshold 70
4.2.176 poe usage-threshold
Command:
poe usage-threshold <1-99>
poe
Power Over Ethernet
usage-threshold
The poe usage-threshold command sets a percentage threshold above which the system sends a
log or SNMP trap.<1-99>: The -threshold percentage configured with this command.
<1-99>
The usage-threshold percentage configured with this command.
Default:
85
Usage Guide:
To configure PoE Usage Threshold.
Example:
To configure PoE Usage Threshold (90 %).
Switch# configure terminal
Switch (config)# poe usage-threshold 90