Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 127)

-127-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect
4.2.65.61 loop-protect action
Command:
loop-protect action [log] [shutdown]
loop-protect
Loo p protection configuration
action
Action if loop detected
log
Generate log
shutdown
Shutdown port
Default:
Shutdown
Usage Guide:
To configure action mode of Loop protection for specific interface
Example:
To configure action mode (log and shutdown) of Loop protection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect action shutdown log
4.2.65.62 loop-protect tx-mode
Command:
loop-protect tx-mode
loop-protect
Loo p protection configuration
tx-mode
Actively generate PDUs
Default:
Enabled
Usage Guide:
To enable tx-mode of Loop protection for specific interface