Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 126)

-126-
Example:
To enable system-name of LLDP TLV for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp tlv-select system-name
4.2.65.59 lldp transmit
Command:
lldp transmit
lldp
LLDP configurations
transmit
Enable/Disabled transmision of LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Tx only mode for specific interface
Example:
To configure LLDP Tx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp transmit
4.2.65.60 loop-protect
Command:
loop-protect
loop-protect
Loo p protection configuration
Default:
Enabled
Usage Guide:
To enable loop-protect for specific interface
Example:
To enable loop-protect for GigabitEthernet X/X