Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 255)

-255-
Switch# configure terminal
Switch (config)# mep 1 performance-monitoring
4.2.143 mep tst
Command:
mep
tst [ dei ] mep-id [ sequence ] [ all-zero | all-one |
one-zero ] rate size
mep Maintenance Entity Point
The MEP instance number.
tst
T est Signal
Priority in case of tagged OAM. In the EVC domain this is the COS-ID.
dei
Drop Eligible Indicator in case of tagged OAM.
mep-id
Peer MEP-ID for unicast TST. The MAC is taken from peer MEP MAC database.
Peer MEP-ID value
sequence
Enable sequence number in TST PDU
all-one
Test pattern is set to all one.
all-zero
Test pattern is set to all zero.
one-zero
Test pattern is set to 10101010.
rate
The TST frame transmission bit rate - in Mega bits pr. second. Limit on Caracal is 400 Mbps. Limit on Serval is
1Gbps. This is the bit rate of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC
MEP, the added tag will give a hi
T ransmission rate value
size
T he TST frame size. This is entered as the wanted size (in bytes) of a un-tagged frame containing TST OAM PDU
- inclu ding C RC (four b ytes). Exam ple when ' Size' = 64 => Un-t agged frame size = DMAC(6) + S MAC(6) +
TYPE(2) + TST PDU LENGTH(46) + CRC(4) = 64
Frame size value
Default:
Usage Guide:
To enable Test Signal of MEP.
Example:
To enable Test Signal of MEP 1 as below table