Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 104)

-104-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # dot1x radius-vlan
4.2.65.16 dot1x re-authenticate
Command:
dot1x re-authenticate
dot1x IEEE Standard for port-based Network Access Control
re-authenticate
Refresh (restart) 802.1X authentication process.
Default:
N/A
Usage Guide:
To restart 802.1X authentication process.
Example:
To restart 802.1X authentication process for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # dot1x re-authenticate
4.2.65.17 duplex
Command:
duplex auto | full | half
duplex Interface duplex
auto
Auto negotiation of duplex mode.
full
Forced full duplex.
half
Forced half duplex.
Default:
Auto
Usage Guide:
To configure duplex mode for interface.