Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 256)

-256-
Switch# configure terminal
Switch (config)# mep 1 tst 3 dei mep-id 2 sequence one-zero rate 10 size 68
4.2.144 mep up
Command:
mep [mip]
up domain { port | evc | vlan } [ vid ] flow level
interface
mep Maintenance Entity Point
The MEP instance number.
mip
This MEP instance is a half-MIP
up
This MEP is a Up-MEP
domain
The domain of the MEP
evc
This MEP is a EVC domain MEP.
port
This MEP is a Port domain MEP.
vlan
This MEP is a VLAN domain MEP.
flow
The flow instance that the MEP is related to.
The flow instance number when not in the port domain.
vid
In case the MEP is a port Up-MEP or a EVC customer MIP the VID must be given.
The port Domain MEP VID. This is required for a Port Up-MEP.
Default:
None
Usage Guide:
To configure Up-MEP of MEP.
Example:
To configure Up-MEP of MEP 2 as below table
Switch# configure terminal
Switch (config)# mep 2 up domain port vid 1 flow 1 level 2 interface GigabitEthernet
1/1