Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 140)

-140-
Default:
None
Usage Guide:
To configure number of Port-security addresses for specific interface
Example:
To configure 100 Port-security addresses for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # port-security maximum 100
4.2.65.85 port-security violation
Command:
port-security violation [protect | shutdown | trap | trap-shutdown]
port-security
Enable/disable port security per interface.
violation
The action involved with exceeding the limit.
protect
Don't do anything
shutdown
Shut down the port
trap
Send an SNMP trap
trap-shutdown
Send an SNMP trap and shut down the port
Default:
None (Protected)
Usage Guide:
To configure protected mode of Port-security for specific interface
Example:
To configure protected mode (trap-shutdown) of Port-security for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # port-security violation trap-shutdown