Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 251)

-251-
4.2.137 mep lm
Command:
mep
lm [ multi | uni ] [ single | dual ] [ fr10s | fr1s | fr6m | fr1m |
fr6h ] [ flr ]
mep Maintenance Entity Point
The MEP instance number.
lm
Loss Measurement
Priority in case of tagged OAM. In the EVC domain this is the COS-ID.
fr10s Frame rate is 10 f/s.
fr1m Frame rate is 1 f/min.
fr1s Frame rate is 1 f/s.
fr6h F rame rate is 6 f/hour.
fr6m Frame rate is 6 f/min.
dual Dual ended LM is based on CCM PDU.
single
Single ended LM is based on LMM/LMR PDU.
multi
OAM PDU is transmitted with multicast MAC.
uni
OAM PDU is transmitted with unicast MAC. The MAC is taken from pe er MEP MAC database. In case of LM
there is only one peer MEP.
flr T he Frame Loss Ratio interval.
The Frame Loss Ratio interval value.
Default:
Usage Guide:
To configure Loss Measurement of MEP.
Example:
To configure Loss Measurement of MEP 2 as below table
Switch# configure terminal
Switch (config)# mep 2 lm 5 uni flr 4