Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 242)

-242-
4.2.124 mep aps
Command:
mep aps [ multi | uni ] { laps | { raps [ octet ] } }
mep Maintenance Entity Point
The MEP instance number.
aps
Automatic Protection Switching protocol
laps
Linear Automatic Protection Switching protocol.
multi
OAM PDU is transmitted with multicast MAC. Must me 'multi' in case of RAPS.
uni
OAM PDU is transmitted with unicast MAC. The MAC is taken from peer MEP MAC database. Only possible in
case of LAPS.
raps
Ring Automatic Protection Switching protocol.
octet
Then last OCTET in the multicast MAC. Only possible in case of RAPS.
Last OCTET value
uni
OAM PDU is transmitted with unicast MAC. The MAC is taken from peer MEP MAC database. Only possible in
case of LAPS.
Default:
None
Usage Guide:
To configure APS of MEP
Example:
To configure APS of MEP 1 as below table
Switch# configure terminal
Switch (config)# mep 1 aps 7 laps
4.2.125 mep cc
Command:
mep cc fr100s | fr10s | fr1m | fr1s | fr300s | fr6h | fr6m
mep Maintenance Entity Point
The MEP instance number.
cc
Continuity Check
Priority in case of tagged OAM. In the EVC domain this is the COS-ID.
fr100s Frame rate is 100 f/s.