Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 90)

-90-
cir
Setup CIR
Committed Information Rate [kbps]
disable
Disable policer
ebs
Setup EBS for MEF policer
Excess Burst Size [bytes]
eir
Setup EIR for MEF policer
Excess Information Rate [kbps]
enable
Enable policer
mode
Setup policer mode
aware
Col or-aware mode
blind
Col or-blind mode
coupled
Cou pling mode
rate-type
Setup rate type
data D ata rate policing
line Line rate policing
type
Setup policer type
mef
MEF ingress bandwidth profile
single
Single bucket policer
Default:
N/A
Usage Guide:
To update a profile for EVC Policer (Ingress Bandwidth Profile).
Example:
To update EVC Policer (Ingress Bandwidth Profile) with EIR 1000 for policer 1
Switch# configure terminal
Switch (config)# evc policer update 1 eir 1000
4.2.56 evc update
Command:
evc update vid ivid interface ( * |
10GigabitEthernet | GigabitEthernet [ ] ) learning [ disable ] policer
{ | none | discard }
EVC identifier
vid
Setup EVC VLAN ID
EVC VLAN ID
ivid
Setup internal EVC VLAN ID