Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 190)

-190-
4.2.70 ip arp inspection translate interface
Command:
ip arp inspection translate interface [10GigabitEthernet | GigabitEthernet]
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
translate
arp inspection translate all entries
interface
arp inspection entry interface config
GigabitEthernet 1 Gigabit Ethernet Port
10GigabitEthernet 10 Gigabit Ethernet Port
Select a VLAN id to configure
Select a MAC address to configure
Select an IP Address to configure
Default:
N/A
Usage Guide:
To translate dynamic entries into static ARP inspection table for specific interface.
Example:
To translate below dynamic entries into static ARP inspection table for GigabitEthernet 1/1.
Switch# configure terminal
Switch (config )# ip arp inspection translate interface GigabitEthernet 1/1 1
00:11:22:33:44:55 192.168.0.18
4.2.71 ip arp inspection vlan
Command:
ip arp inspection vlan logging all | deny | permit
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
vlan
arp inspection vlan setting
arp inspection vlan list