Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 311)

-311-
4.2.213.4 no
Command:
no
no
Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function
Example:
To disable the function (spanning-tree auto-edge)
Switch# configure terminal
Switch (config)# snmp-server host Interlogix
Switch (config-snmps-host)# no spanning-tree auto-edge
4.2.213.5 spanning-tree auto-edge
Command:
spanning-tree auto-edge
spanning-tree
Spanning Tree protocol
auto-edge
Auto detect edge status
Default:
Enabled
Usage Guide:
To enable the Auto Edge of CIST Aggregated Port
Example:
To enable the Auto Edge of CIST Aggregated Port
Switch# configure terminal
Switch (config)# snmp-server host Interlogix
Switch (config-snmps-host)# spanning-tree auto-edge