KMC Controls BAC-8007 Installation Guide - Manual (Page 5)

S e c t i o n 1 : A b o u t t h e c o n t r o l l e r s
This section provides a description of the SimplyVAV series of
controllers. It also introduces safety information. Review this material
before selecting, installing, or operating the controllers.
The SimplyVAV series of controllers are an easy and unique approach to
operating a wide variety of VAV terminal units. The integrated actuators,
internal airflow sensors, and wide variety of application programs make these
BACnet Application Specific controllers ideal for either new or retrofit
installations.
The controllers feature simple, menu driven setup choices when used with a
SimplyVAV digital sensor. No special programming skills or software tools
are required to choose applications, enter setpoints, set network addressing,
and balance airflow. All options can be set by using only an STE-8001 sensor
which can be installed as the permanent room sensor or temporarily
connected as a technician’s service tool.
All models are BACnet Application Specific Controllers that are ready to
connect to a BACnet MS/TP network. Device instance, MAC address, and
baud rate are set from an STE-8001 without special software.
BAC-8001 Model BAC-8001 is supplied with inputs, outputs, and sequences
of operation for the following functions.
Single duct heating and cooling VAV
Automatic heating/cooling changeover including morning warmup
Occupancy setback—requires STE-8201
System diagnostic indicators
Airflow balancing
SimplyVAV
Revision E 5